CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Convert Dev board to 3.3V

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
doubleE



Joined: 15 Oct 2008
Posts: 7

View user's profile Send private message

Convert Dev board to 3.3V
PostPosted: Wed Oct 22, 2008 5:55 pm     Reply with quote
I'm working on a Finger navigation device for a cell phone application which is 3.3V max. I have the Embedded Serial Bus Development Board which is 5V. Will the board work properly if I convert it and run it at 3.3V? I know I could probably look up the specs for each IC but I'm hoping someone here have already tried it and can give me a quick answer.

Thanks for looking.
Eric
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu Oct 23, 2008 2:23 pm     Reply with quote
CCS doesn't post the schematics. There is no easy way to help you.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group