CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Wizard Setup Issue

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Guest
Wizard Setup Issue
PostPosted: Fri Mar 06, 2009 2:22 pm     Reply with quote
When using the wizard setup for Pic16F690 I go and assign spi hardware and then look on the i/o tab and it sets the wrong i/o pins for the spi lines. Is this a problem that I should worry about or is it just a fluke in ccs. Also if I use an 18f8722 I go and select both spi1 hardware and spi2 hardware but only spi1 appears on the i/o tab. Is spi2 still being set?
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Fri Mar 06, 2009 2:36 pm     Reply with quote
Always post your compiler version, so people who have the same version
of the IDE can try to help.
Guest
PostPosted: Fri Mar 06, 2009 2:43 pm     Reply with quote
Im using PCWHD 4.068
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group