CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Ez Web Lynx module

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
irkgreen



Joined: 16 Oct 2008
Posts: 1

View user's profile Send private message AIM Address Yahoo Messenger MSN Messenger

Ez Web Lynx module
PostPosted: Thu Oct 16, 2008 9:06 am     Reply with quote
I just purchased the EZ Web Lynx module and was curious if anyone has used them to control other circuits? Mostly I aim to use the device to monitor switches; which seems easy enough (short one of the digital data pins to ground). However, I am not as clear on how you would control a circuit. It seems you can change the status of a pin via software, but how could you then use that new status to control a device? Would you use a reed relay or opto-isolator? It doesn't seem that there are many components like these that would operate at 3.3 V.

Has anyone done this?

Eric
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group