I need to use only one Port B pin with an internal pullup. According to the datasheet this is possible by setting up RABPU[bar] and setting the proper bits in the WPUB register.
The other Port B pins are as follows:
Portb.4 = I2C Data
Portb.5 = I need this one to have its internal pull up enabled.
Portb.6 = I2C Clock
Portb.7 = Digital Output
I didn't see a specific function or command in the CCS libraries to modify the WPUB register and set or clear the RABPU[bar] register.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum