On my PIC 16 it worked fine with the AD conversion. Using the same code on PIC18 the reading on RA2 affects the value on RA0.
Has anyone experienced the same?
I use the latest compiler.
/Christer
___________________________
This message was ported from CCS's old forum
Original Post ID: 13133
EECEWOLF Guest
Re: Ad conversion on PIC18
Posted: Thu Mar 27, 2003 9:35 am
Which PIC16? The PIC18 has a 10-bit A/D. Is it setup to be left justified or right justified?
:=On my PIC 16 it worked fine with the AD conversion. Using the same code on PIC18 the reading on RA2 affects the value on RA0.
:=Has anyone experienced the same?
:=I use the latest compiler.
:=/Christer
___________________________
This message was ported from CCS's old forum
Original Post ID: 13139
Neutone
Joined: 08 Sep 2003 Posts: 839 Location: Houston
Re: Ad conversion on PIC18
Posted: Thu Mar 27, 2003 9:43 am
:=Which PIC16? The PIC18 has a 10-bit A/D. Is it setup to be left justified or right justified?
:=
:=
:=:=On my PIC 16 it worked fine with the AD conversion. Using the same code on PIC18 the reading on RA2 affects the value on RA0.
:=:=Has anyone experienced the same?
:=:=I use the latest compiler.
:=:=/Christer
Did you pause after switching channels?
___________________________
This message was ported from CCS's old forum
Original Post ID: 13140
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum