CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
newbie

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
rev



Joined: 10 Dec 2007
Posts: 1

View user's profile Send private message

newbie
PostPosted: Mon Dec 10, 2007 3:30 am     Reply with quote
Hi all, am new to this and would like a pointer in the right direction.

I have compiled a project and want to run it in MPLAB in simulation mode.

I assume I open MPLAB and load the .coff file. This does not seen to work.

Not sure what I an doing wrong.

Any info would be greatly appreciated.

Regards

Paul
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Mon Dec 10, 2007 10:20 am     Reply with quote
http://www.ccsinfo.com/forum/viewtopic.php?t=23408&start=1
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group