CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ICD2 start problems

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Guest
ICD2 start problems
PostPosted: Thu Nov 01, 2007 10:34 am     Reply with quote
Hello,

I have a ICD2 board with a serail interface and I have Vista on my PC.
when I install the MPLAB IDE all is OK but when I connect the ICD2 board with my PC and try to install the driver for serial interface then the system asks for a confirmation that this system is a 32 bit system.

My ICD2 board is not the original one, it is a replication.

I don't know what I should do now please help me

thank's face969 Crying or Very sad
frequentguest
Guest
PostPosted: Thu Nov 01, 2007 11:16 am     Reply with quote
This forum is for help with the CCS compiler. Not knock-off ICD2s. This probably isn't the best place to be asking for help.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group