CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Which function for voltage input?

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
ThomasC



Joined: 09 Oct 2007
Posts: 62

View user's profile Send private message

Which function for voltage input?
PostPosted: Mon Oct 22, 2007 3:02 pm     Reply with quote
I have a pic 16F690 on a pickit2 board.

I would like to take an input voltage through pin AN8 to perform a calculation with it.

Which function should I use? Thanks for helping this noobie.
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Mon Oct 22, 2007 3:54 pm     Reply with quote
The read_adc() function is used to read an analog voltage.
See this thread for some setup code.
http://www.ccsinfo.com/forum/viewtopic.php?t=25217&start=4
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group