CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Minimum for CCS' TCP/IP stack to work with TCP comms

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
javick82



Joined: 12 Jul 2007
Posts: 43

View user's profile Send private message

Minimum for CCS' TCP/IP stack to work with TCP comms
PostPosted: Fri Jul 27, 2007 9:00 am     Reply with quote
What are all the files needed for the TCP/IP stack to work if I only want to use TCP communication?

I am using the PICDEM.net 2 board with the 18F97J60 microcontroller and ENC28J60 ethernet chip. Required reconfiguration of the hardware.h file to get it to run, I just want to make sure I am not including unnecessary code.

Thanks!
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group