Program Mode Set to Fast Warning During Compile

[kuriken]

Hello,

I get the following warning when I compile my code. I have CCS PCH C Compiler, Version 4.042. I am loading the code to my PIC with a ICD-U40. My microcontroller is 18LF4620 with a 20MHz external crystal oscillator. The VDD on my PIC is regulated to 3.3V. Where are the program modes option?


**WARNING**
The current program mode is set to fast.
Fast mode only works with 5V devices. The current voltage level is: 3.17
There may be problems programming target devices if you don't change it to normal mode.
Use the program modes option from the


My code runs fine but I am wondering if this problem is going to rear its head at the worst possible moment.

Please help,


Ken