CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Emc clear graphic lcd display

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Turky



Joined: 08 Jun 2007
Posts: 2

View user's profile Send private message

Emc clear graphic lcd display
PostPosted: Fri Jun 08, 2007 5:24 pm     Reply with quote
I use PIC18F6627 and AM12864 graphic display. This board drive inductive loads which sometimes generate emc interference and clear display. Display stay cleared all time and only way to show picure is run initialization procedure and generation picture again. Can I use more intelligent way by checking busy flag and run initialization when no answer from display?
OK, I know, I must cancel emc, but this software solution is backup for 100% safety.
Thanks. Turky
Turky



Joined: 08 Jun 2007
Posts: 2

View user's profile Send private message

PostPosted: Mon Jun 11, 2007 1:19 am     Reply with quote
I was wrong in previous mail. It is possible to do "diplay off" and "display on" and picture is shown on display. It is very short command, display picture is very quickly and this eliminate "blinking effect".
Best wishes.
Turky
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group