CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
correct inizialization of i2c bus

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Fabri



Joined: 22 Aug 2005
Posts: 275

View user's profile Send private message

correct inizialization of i2c bus
PostPosted: Tue May 09, 2006 10:16 am     Reply with quote
Hi Everibody,

Sometimes, after power-up, the i2c bus doesn,t work and I have to restart the equipment.

I have a doubt about:

Does #use i2c() inizialize direction register, port level and stop status or must I do that manually ?

Any suggestion about ?

Thanks for support,
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue May 09, 2006 12:01 pm     Reply with quote
The library code does setup the TRIS, and it sets up the i2c registers
if you're using hardware i2c.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group