I'm using CCS-PCWH v3.235 and ICD-U40 to write and debbug my PIC18F4550 board.
I am able to compile and the run the program using the debbug mode in the compiler.
But when i try to burn the code independently using the icd.exe i am unable to connect and detect the target chip.
The icd-u40 shows COM3 as the only port, to which i am unable to connect. I dont understand souldn't it detect a USB port instead of COM port. Is it a problem with the windowsXP that i dont have any access to the ports?
Any suggestion to get the program working without using the debugger mode?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum