ICD0161: (CMemory::Verify) Verify failed (MemType = Program,

[Chen]

It is really frustrating.

I have a program for PIC18F8620. Everything programs fine. I simply add one declaration:

int8 temp8;

and the ICD2 will give the error message of

ICD0161: (CMemory::Verify) Verify failed (MemType = Program, Address = 0x7972, Expected Val = 0xFFFF, Val Read = 0xFFFE)

Any idea?

Thanks!
___________________________
This message was ported from CCS's old forum
Original Post ID: 13008

[Chen]

1) I tried the same board on another PC, and it worked there.

2) Swap the two ICD2 I have, doesn't make any difference

3) Notice extra message after compiling with CCS:
ICD0157: (CICDAPI::ValidateAccessRequest) Access type and mode not allowed for this memory (Mem = Data) (Mode = ICSP) (Type = Read)
ICD0151: (CMediator::Synch) Failed to sync memory (MT = Data) (Dir = 0x0)

4) Once it had trouble, it will continue have trouble for a few time, even removing the line I added
___________________________
This message was ported from CCS's old forum
Original Post ID: 13009

[Chen]

The problem is in MPLB ICD2: Ground loop in the system
___________________________
This message was ported from CCS's old forum
Original Post ID: 13026

[Guest]

I'm getting this problem as well
Do you really think it is just the PC???
Where did you get the information on the ground loop??