CCS :: View topic - Input() Function

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

Input() Function

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

sonicdeejay

Joined: 20 Dec 2005
Posts: 112

Input() Function

Posted: Thu Mar 02, 2006 9:23 am

Guys

I has some issue with input() function,
My code is below:

Code:

#include <18F2525.h> // Call for PIC18F2525 Driver
//#device ICD=TRUE
#device ADC=10 // Use 10bits ADC
#fuses HS,NOWDT,NOPROTECT,NOLVP
#use delay(clock=16000000) // 16Mhz Crystal is Used
#use rs232(baud=9600, parity=N, xmit=PIN_C6, rcv=PIN_C7, bits=8)

#include <MAX517mod.c>
#byte PORTB = 0xf81
#byte PORTC = 0xf82

#include <stdlib.h>
#include <math.h>

//Start main program
void main()

{

// ADC Port Initialisation
setup_port_a( AN0_TO_AN3 | VSS_VDD );
setup_adc( ADC_CLOCK_INTERNAL );

while(1)

{

output_high(PIN_C5); // Power On LED
delay_us(100);

while ( !input(PIN_A2) );

// waits for freq ready signal from A2

output_low(PIN_C5);//LED OFF

printf("\n\r we got A2 signal ON");

}

}

Even though I tied PIN_A2 with 5V.... It won't proceed the later "printf" statment....

Did I miss something?
Do I have to define PORT A as INPUT??(SET_TRIA???)

thx in advance...

sonic
Smile

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum