LCD.C Driver Question

[noplacelikehome]

I'm a TOTAL newbie to the PIC 16f877. the LCD driver provided by CCS is to be used on PORT B and PORT D (see below). BUT, I'm currently using PORT B for something else. Can I switch to PORT C? From the 16f877 datasheet I noticed that there is no 'option_reg' for PORT C, are there any alternatives? HELP!! Thanks.
--------------------------------------------------------------------
#if defined(__PCH__)
#if defined use_portb_lcd
#byte lcd = 0xF81 // This puts the entire structure
#else
#byte lcd = 0xF83 // This puts the entire structure
#endif
#else
#if defined use_portb_lcd
#byte lcd = 6 // on to port B (at address 6)
#else
#byte lcd = 8 // on to port D (at address 8)
#endif
#endif

#if defined use_portb_lcd
#define set_tris_lcd(x) set_tris_b(x)
#else
#define set_tris_lcd(x) set_tris_d(x)
#endif
-------------------------
Also, my LCD has 4 lines. Can the code be modified to:

#define lcd_type 4
#define lcd_line_two 0x40 // LCD RAM address for the 2nd line
#define lcd_line_three 0x10 //LCD RAM address for 3rd line
#define lcd_line_four 0x50 //LCD RAM address for 4th line

void lcd_gotoxy( BYTE x, BYTE y)
{
BYTE Data;
if(y=2)
Data=lcd_line_two;
else if (y=3)
Data=lcd_line_three;
else if (y=4)
Data=lcd_line_four;
else
Data=0;
Data+=x-1;
lcd_send_byte(0,0x80|Data);
}

[PCM programmer]

[noplacelikehome]

Thanks!