CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
mixing soft and hard UARTs in PIC16F877A

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
EmbdFreak



Joined: 28 Jul 2005
Posts: 23

View user's profile Send private message

mixing soft and hard UARTs in PIC16F877A
PostPosted: Sun Aug 21, 2005 6:12 am     Reply with quote
Hi all,

Can we use the hardware UART (pinC6,C7) while dedicating the other two pins (say C1,C2) for using in the software UART in the same program?Does the compiler lets us do so, or would we need to change the software uart pin to some other port ?
StuartH



Joined: 19 Aug 2005
Posts: 14
Location: W. Midlands, UK

View user's profile Send private message

PostPosted: Sun Aug 21, 2005 7:38 am     Reply with quote
Short answer is yes, you can.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group