CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
16f628 and Mplab

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Fredbor
Guest
16f628 and Mplab
PostPosted: Fri Feb 06, 2004 4:04 am     Reply with quote
i am using a 16f628 with INTRC_IO for the clock. Timer0 generate an intteruption every 200 µs. when i make a simulation on Mplab all is good, but when i transfert the soft in the 16f628 nothing appens. Somebody can help me?. Thank you
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Sun Feb 08, 2004 3:51 pm     Reply with quote
Make sure that the Config Bits are setup correctly, when you
program the PIC in MPLAB. CCS calls these bits "fuses".
What programmer are you using ? PicStart-Plus ? or ICD2 ?
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group