How should MPLab 6.12 and CCS be setup to carry parameters

[PeterD]

Hi all,

I have just downloaded V 6.12 of MPLAB IDE and PSF31001.HEX for my PICSTART programmer so that I can program PIC12F675's.

I had Rev 5.70 of MPLab running with ccs for PIC12CE674 devices and all was fine.

Now the paramaters don't get passed to MPLab

I have changed the ccs programmer / Debugger options from :


WARP-13 C:\PROGRA~1\WARP13\WARP13.EXE podpic.hex /16F877
ICD "c:\program files\picc\ICD-S.EXE" \T\%H

MPLAB c:\program files\mplab\mplab.exe \%P
Blank Blank
Blank Blank

to

WARP-13 C:\PROGRA~1\WARP13\WARP13.EXE podpic.hex /16F877
ICD "c:\program files\picc\ICD-S.EXE" \T\%H

MPLAB C:\Program Files\MPLAB IDE\dlls\MPlab.exe \%P
Blank Blank
Blank Blank

And MPLAB opens but no program data gets passed.

Can anyone tell me where I am going wrong?

Thanks in advance

Peter
___________________________
This message was ported from CCS's old forum
Original Post ID: 11230

[kolio]

:=Hi all,
:=
:=I have just downloaded V 6.12 of MPLAB IDE and PSF31001.HEX for my PICSTART programmer so that I can program PIC12F675's.
:=
:=I had Rev 5.70 of MPLab running with ccs for PIC12CE674 devices and all was fine.
:=
:=Now the paramaters don't get passed to MPLab
:=
:=I have changed the ccs programmer / Debugger options from :
:=
:=
:=WARP-13 C:\PROGRA~1\WARP13\WARP13.EXE podpic.hex /16F877
:=ICD "c:\program files\picc\ICD-S.EXE" \T\%H
:=
:=MPLAB c:\program files\mplab\mplab.exe \%P
:=Blank Blank
:=Blank Blank
:=
:=to
:=
:=WARP-13 C:\PROGRA~1\WARP13\WARP13.EXE podpic.hex /16F877
:=ICD "c:\program files\picc\ICD-S.EXE" \T\%H
:=
:=MPLAB C:\Program Files\MPLAB IDE\dlls\MPlab.exe \%P
:=Blank Blank
:=Blank Blank
:=
:=And MPLAB opens but no program data gets passed.
:=
:=Can anyone tell me where I am going wrong?
:=
:=Thanks in advance
:=
:=Peter

Hi,
My warm recommendation is to stay with MPLAB 5.70.40 and PICSTART OS Ver. 3.10.00. It works STABLE with 12F6xx.
I had a lot of troubles trying to use the new MPLAB 6.xxx.
May be it is good (even necessary) for the other uCs (PIC18 and dsPIC), but didn't help me with 12F6xx. I also had some postings about that problems before.
Wish you luck,
Kolio
___________________________
This message was ported from CCS's old forum
Original Post ID: 11259

[koala]

could you find a fix for this inconvenience?